采用小型反渗透装置，研究各因素对海水反渗透膜脱硼性能的影响。结果表明：试验用海水膜脱硼性能优于苦咸水膜和FILMTEC海水膜；不调节pH下脱硼率为60%～80%，调节pH值脱硼率可高达98%以上；pH≤8.0条件下，脱硼率随进水压力增大显著提高，当pH≥9.5则影响减小；此外，海水膜的脱硼率基本不受元件回收率和进水硼浓度的影响。因此，提高pH值和进水压力能有效改善反渗透脱硼性能。

 Experiments of removing boron using SWRO membrane were carried out on a pilot equipment. Results show that boron rejection performance of test SWRO surpass BWRO & FILMTEC SWRO. Boron rejection at natural pH is 60%～80% and can reach above 98% by adjusting pH. When feed water pH≤8.0 boron rejection evidently raises following pressure increasing and the influence diminishes at pH≥9.5. In addition, boron rejection of SWRO is independent on recovery ratio and feed boron concentration. So improving feed water pressure and pH can effectively promote the boron removing performance of RO membrane.

[1]M. Rodriguez Paastor, A. Ferrandiz Ruiz, ect. Influence of pH in the elimination of boron by means of reverse osmosis.[J]. Desalination, 2001, 140:145-152.
[2]D. Parts, M.F. Chillon-Arias,ect. Analysis of the influence of pH and pressure on the elimination of boron in reverse osmosis.[J]. Desalination, 2000, 128:269-273.
[3]王晓伟, 贾铭椿, 等. 反渗透膜对水中硼酸脱除性能的实验研究.[J]. 膜科学与技术, 2011, 31(6).
[4]王晓伟, 杨开, 等. 反渗透处理模拟含硼放射性废水的实验研究.[J]. 核动力工程, 2012, 33(4).
[5]Jorge Redondo, Markus Busch, ect. Boron removal from seawater using FILMTECTM high rejection SWRO membranes.[J]. Desalination, 2003, 156:229-23.